MTD RZT Series Manuale dell'Operatore Scaricare il pdf (Pagina 8)

Assembly & Set-Up

TRACTOR PREPARATION

Remove the upper crating material from the shipping

pallet, and cut any bands or tie straps securing the tractor

to the pallet.

Use the lift handle to raise the deck to its highest position.



tractor; then carefully roll the tractor off the shipping

pallet. Disengage the bypass rods. See Figure 3-1.

Figure 3-1

Remove the deck wash system nozzle adapter from the

manual bag and store for future use.

Install Operator’s Seat



pivot bracket for shipping purposes. To install the seat

proceed as follows:

Cut any straps securing the seat assembly and the 1.

drive control levers to the tractor. Remove any packing

material.

NOTE: The seat is partially inserted into the slots of the seat

pivot bracket. If the seat does not become disengaged from

the pivot bracket when removing the packaging material, the

pivot bracket may be pivoted upward and the seat pushed

into place as described in step 6. If the seat does disengage the

pivot bracket, install the seat as instructed in steps 2 thru 6.

2.

Figure 3-2.

Note the grooves in the seat adjust spacers attached 3.

to the bottom of the seat, then lift the seat and

position above and to the rear of the pivot bracket.

Align the grooves in the seat adjust spacers with the 4.

sides of the adjustment slots in the pivot bracket.

Slide the seat adjust spacers into the slots of the pivot 5.

bracket.

Continue to push the seat forward in the pivot bracket 6.

until the front/left shoulder bolt of the seat assembly

passes forward of the stop bracket on the seat pivot

bracket. See Figure 3-2.

Figure 3-2

Adjusting Operator’s Seat” in Maintenance &

Adjustments for seat adjustment instructions.

Position Drive Control levers

The drive control levers of the tractor are lowered for

shipping purposes. The flange lock nuts, hex screws, and

flat washers that normally secure the control levers in

their operating position are unfastened and installed in

the slotted holes of the control levers for shipment. The

control levers must be repositioned to operate the tractor.

To reposition the control levers for operation, proceed as

follows:

Remove the hex screw, flat washer, and flange lock nut 1.

from the slot of one of the drive control levers.

Lift and swing that control lever upward until the 2.

slotted hole in the lever bracket aligns with one of the

holes in the pivot bracket. Refer to Figure 3-3.

Slide the flat washer onto the hex screw. From the 3.

outside, insert the hex screw w/washer through the

control lever slot and the hole of the pivot bracket.

Secure with the flange lock nut. Refer to Figure 3-3.

Note the relative position of the control lever to 4.

the pivot bracket, then repeat the previous steps to

Contents of Crate

  

 

Manual







RH Transmission

Bypass Rod

Keystone

Slot

Pull out

Bypass Rod

in Slot

Then Lower

Seat

Adjust

Spacer

Seat

Front/Left

Shoulder Bolt

Seat

Pivot

Bracket

Seat Adjust

Lever

Stop Bracket

Adjustment

Slots

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commenti su questo manuale

Nessun commento

MTD RZT Series Manuale dell'Operatore Pagina 8

Commenti su questo manuale

Prodotti e manuali riguardandi Trattori MTD RZT Series