Mtd 24638S Manuale Utente

OUTDOOR POWER EQUIPMENT for all seasonsImportant:Read Safety Rules and Instructions Carefully3-1/2 H.P. LOG SPUTTERModel Numbers 245-638-000 24638S

FIGURE 13FIGURE 155. Using a 9/16" wrench, remove the engine pu ley by removing the hex bolt and lock washer. See figure 14. Sli

TROUBLE SHOOTING CHARTSYMPTOMPOSSIBLE CAUSE (S)SOLUTION^ Engine fails to startA. Check fuel tank for gas.B. Spark plug lead wiredisconnected.C. Fau

Model 638IF YOU WRITE TO US ABOUT THIS AftllClE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIAL NO MODELNOTEThis instruction

Model 638PARTS LIST FOR MODEL 638 LOG SPLITTERi>lO.PARTIMO.COLORCODEDESCRIPTIONNEWPARIREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1717-08162-1/2"

Model 6381&22-1/2" DIA. CYLINDER PARTS LIST FOR MODEL 638REF.NO.PART NO. DESCRIPTIONNEWPART1 717-0816C\ linder Ass'y- Comp.N2 753-0392 2

MTD PRODUCTS INC ... YSRO-MSN COMPANYP.O. BOX 3690D • CLEVELAND OHIO 44136

INDEXSafe Operation Practices... 3Assembly Instructions... 5Ope

AIMPORTANTIt is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep this manual -*cka safe place for fut

11. Never attempt to split wood across the. g ain. Some types of wood may burst or fly out of your splitter and result in injur

G-H-FIGURE 1ASSEMBLY INSTRUCTIONSTOOLS REQUIRED(1) Raw Hide or Plastic Hammer (1) 3/4" Wrench or Adjustable Wrench (1) Pair of PliersOTHER MATERI

LEFT HAND SIDE OF SPLITTERFIGURE4Slide spacer (J) onto axle shaft on the left hand side of the splitter. Spacer should be on the engine side

9. Place the flattened end of the engagement handle (0) down through the slotted bracket beside the beam. Place shoulder bolt (A)

NOTEDO NOT operate log splitter without proper amount of oil in reservoir tank (beam).2. Fill sump with oil as instructed in the s

AI WARNING JNever attempt to cut a log in half with the log splitter.Never stand next to the ram when operating. Always stand behind theram.MAINTENANC