Mtd 241-645A Manuale Utente

ASSEMBLY » OPERATION » MAINTENANCE « PARTS8 H.P. LOG SPLITTERImportant:Read Safety Rules and Instructions CarefullyThank you for purchasing an Amer

Tighten hex locknut and operate log splitter. Repeat if necessary.3. With an adjustable wrench remove the strainer tube assembly. See figure 1

NOTEFIGURE 19Check oil in log splitter reservoir before every use.See figure 20.1. Block up front of log splitter so beam is setting level.2

241-645A12

241-645APARTS LIST FOR LOG SPLITTER MODEL No. 241-645A PartNo.ColorCodeDESCRIPTIONNewPartRef.No.PartNo.ColorCodeDESCRIPTIONNewPart1717-0407Control Val

241-645A4" DIA. CYLINDER PARTS LIST FOR MODEL 241-645ARef.No.PART No.DESCRIPTIONNewPart1717-0406Cylinder Ass'y- Comp. (Welded Push Plate)N27

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the authorized

INDEXSafe Operation Practices... 3List of Contents in Hardware Pack ... 4Ass

IM PORTANTIt is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep this manual in a safe place for futu

TOOLS REQUIRED:(1) Raw Hide or Plastic Hammer (1) 1-1/8" Wrench or Adjustable Wrench (1) 3/4" WrenchOTHER MATERIALS NEEDED:(A) One gallons

3. Thread hex castle nut (C) on axle. Tighten castle nut until snug, back off approximately 1/3 turn or until one of the slots o

;♦DEXPOINi TRAWSIVIIi»: FLUIDFUNNELBREATHERTUBE...FIGURE 6FIGURE?ACAUTIONYou must not operate log splitter without proper amount of oil

The ram should take approximately 30 seconds to make a complete cycle. This speed may vary depending on throttle setting and temperature

TO STOP ENGINE1. Move throttle control lever to STOP position. See figure 8.2. Remove high tension wire from spark plug to prevent ac

NOTEIf you lock the engagement handle in the reverse slot, "^e ram will return until it hits the return stroke stop lunger, which will throw the