Mtd 111-902A Manuale Utente

.50ASSEMBLY » OPERATION « MAINTENANCE » PARTS22" ROTARY MOWERSImportant:Read Safety Rules and Instructions CarefullyThank you for purchasing an A

FIGURE 13.SPARK PLUGThe spark plug should be cleaned (see figure 12) and the gap reset to a 0.030-inch clearance once a season (see figure 13). Spark

NOTEThe manufacturer DOES NOT recommend the use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer.GRASS CA

111-902A111-902-026IF YOU WRITE TO US ABOUT THIS ARTICLE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIAL NO MODEL

111-902A 111 -902-026PARTS LIST FOR 111-902A AN D 111 -902-026REF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1710-0

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the authorized

INDEXSafe Operation Practices...3Assembly Instructions...4Operation...

^ WARNING \To reduce the potential for any injury, comply with thethe instructions may result in personal injury.SAFE OPERATION PRACTICESTRAINING1. I

LowerHandleInnerHoleOuterHoleWeld PinFIGURE 1.ASSEMBLYINSTRUCTIONSNOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see operatin

CableFIGURE 4.\Chute DeflectorShipping Block ^ To Be RemovedFIGURE 5.5. Secure throttle control cable to handle with — ties provided. See figur

OPERATIONCAUTIONDO NOT OPERATE MOWER UNLESS GUARD OR ENTIRE GRASS CATCHER IS IN ITS PROPER PLACE.Keep hands and feet away from the chute area o

Low Position High PositionFIGURE?.THROTTLEIf adjustment becomes necessary, the throttle control wire assembly can be reset as follows:1. Loosen,

CUTTING BLADEA. Removal for Sharpening or ReplacementFIGURE 9.LUBRICATIONIMPORTANTAlways stop engine and disconnect spark piug wire before cleani

Blade Mounting Torque3/8" Dia. Bolt 375 in. ib. min., 450 in. lb. max.5/16" Dia. Boit 150 in. ib. min., 250 in. Ib. max.To insure safe op