Mtd 380 Manuale Utente

Two-Stage Snow ThrowerModel 380PRINTED IN U.S.A.Operator’s ManualFORM NO. 769-00747A.fm(6/2003)IMPORTANT: Read safety rules and instructions carefully

10NOTE: Your unit is equipped with a clutch in thetransmission. If the wheels stop turning while trying todischarge large volumes of snow, immediatel

11EngineListed below are general recommendations about maintaining your snow thrower engine. For further details, refer to the accompanying engine man

12• Reassemble new shave plate, making sure heads of the carriage bolts are to the inside of the housing. Reinstall skid shoe. Tighten securely. Figu

13Servicing AugersThe augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a foreign object or ice jam, the snow

14SECTION 8: TROUBLESHOOTINGNOTE: For repairs beyond minor adjustments listed above, contact an authorized service dealer.Problem Possible Cause Reme

15SECTION 9: PARTS LIST FOR MODEL 3801234567891011121314151661718192021222324252627172829303132333429223536373839Ref. No. Part No. Description1. 710

16Model 3801234567891011121314151617181920212223242526272829Shown for reference only16Shown for reference only30

17Ref. No. Part No. Description1. 710-0654A TT Sems Screw 3/8-16 x 1.0”2. 710-0696 Hex Bolt 3/8-24 x 0.875”3. 710-1245B Lock Bolt 5/16-24 x 0.875”4. —

18Model 380Shown for reference only12345678910111213141516171819208916212223242526272829303132333435363738404148434445464748495051524239

19Model 380Ref. No. Part No. Description1. 684-04037 Chute Assembly2. 710-04071 Carriage Bolt 5/16-18 x 1.0”3. 710-0451 Carriage Bolt 5/16-18 x 0.750”

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices ...3Assembli

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESDANGER: This machine was built to be operated according to the rules for safe operation in this manual.

45. Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 6. Do not operate

5SECTION 2: ASSEMBLING YOUR SNOW THROWERIMPORTANT: This unit is shipped with engine oil but without gasoline in the engine. After assembly, see page

6Final AdjustmentsIMPORTANT: Check the adjustments as instructed and make any final adjustments necessary before operating the unit. Check all nuts an

7SECTION 3: KNOWING YOUR SNOW THROWER• Compare Figure 6 with your equipment and follow description of controls, given below, to get familiar with the

8SECTION 4: OPERATING YOUR SNOW THROWERBefore Starting EngineEngine OilThe engine is shipped with oil in it. Check the oil level before first use. Fo

9the snow thrower starter will normally be used, one should be installed by a licensed electrician.NOTE: When connecting the power cord, alwaysconnec