Mtd 249-620-003 Manuale Utente

DUtRRMODEL NUMBER PRO/20 (249-620-003)LOG SPLITTERIMPORTANT:•Read this Manual Before Attempting to Assemble and UseRead Safety Rules and Instructions

5. Move the control handle to reverse position to return the splitting wedge.FIGURE 13.—Vertical OperationTO OPERATE LOG SPLiTTER:1. Set thro

3.Back the two adjustment bolts on the side of the slide plate out slowly until the wedge assembly will slide on the beam. Tighten the l

Clean the engine regularly with a cloth or brusli. Keep the cooling system (blower housing area) clear to permit proper air circulation which is

3. Protect the inside of the engine for storage as follows.Remove spark plug, pour approximately V2 ounce (approximately one tablespoon)

Trouble Shooting GuideTroublePossible Cause (s)Corrective ActionEngine fails to start1. Fuel tank err pty, or stale fuel.2. Blocked fuel line.3. Sp

HOW YOUR LOG SPLITTER OPERATESGear SectionTHE PUMPA two-stage log splitter pump has one large and one small ^ar section, using common inlet a

I IPRO/20 (Model 620)6PEftfa\0N VR£SS\}KE asoó TO 30ÙO PsiHINOTESpecifications subject to change without notice or obligation. M16

PRO/20 (Model 620)PARTS LIST FOR MODEL 620 LOG SPLITTERlEF.»lO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODE DESCRIPTION1 736-0119L-Wash. 5/16" I.D.*4

HYDRAULIC TROUBLE SHOOTING GUIDEProblemProbable C ause(s)Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupling C Gear

ч

IMPORTANT INFORMATION FOR LOG SPLITTER USERSALWAYS:Use clean fluid and check fluid level regularly Use Dexron II Automatic Transmission Fluid Use a fi

18 MONTH LIMITED WARRANTYNON-COMMERCIALNON-TRANSFERABLELimited to Modeis PRO/20 and 424/LCD/22 Log SpiittersFor 18 months from the date of original re

IMPORTANTRULES FOR SAFE OPERATION▲THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/

2. Know how to stop the unit and disengage the controls.3. Never place hands or feet between log and splitting wedge or between log and end plate dur

IMPORTANTThis unit has been shipped without gasoline or oil in the engine. After assembly, refer to separate engine manual for proper

INSTALLING THE HITCH1Using two 9/16" wrenches, remove the two long hex bolts, lock washers and hex nuts which are assembled throu

ATTACHING THE ENGINE AND PUMP ASSEMBLY1. Using two 1/2" wrenches, remove the four hex bolts, lock washers and hex nuts which secure the b

PressureHoseControlValvePressure HoseThe pressure hose is attached to the top of the pump. -Route the hose as shown in figure 10. Place the metal pres

BEFORE STARTINGBefore each use, check the following:1. Place log splitter on a firm, level surface. For vertical operation, remove the quick rel