Mtd 243-638-000 Manuale Utente

$1.00 ~N.OWNEirS GUIDE• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •VERTICAL LOG SPLITTERModel Number 243-638-000IMPORTANT!Record the Model No. an

TO START ENGINEIMPORTANT: Refer to the separate engine manual for detailed starting instructions for your model.1. Place the engine shut-off sw

TO OPERATE LOG SPLIHER:1. Set throttle at maximum speed.2. Place the log upright, on top of end plate for vertical operation, and on top of beam fo

CARBURETOR ADJUSTMENTAWARNING: If any adjustments an; made to the engine while the engine is i unning (e.g. carburetor), keep clear of all noving

6.2. Using a 1/2 inch wrench, remove three nuts and lock washers which secure the pump to the coupling shield. Two nuts are at the bottom corners a

TROUBLi; SHOOTING GUIDETroublePossible Cause(s)Corrective ActionEngine fails to start1. Fuel tank empt'', or stale fuel. 1. Fill tank with c

HOW YOUR LOG SPLITTER OPERATESCylinder□^ CylinderDirectionalValveRelief ValveBreather Cap Unloading Valve 'PilotPressureLinePumpReservoirTHE PUMP

Model 638NOTE: The engine is not under warranty by the iog spiitter manufacturer. . .if repairs or service is needed on the engine, please contact you

Model 638PARTS LIST FOR MODEL 638 LOG SPLITTER<4EF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1 712-0359Slotted Nut 3/4-16 Thd.55781-037

HYDRAULIC TROUBLE SHOOTING GUIDEProblemProbable Cause(s) Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupf ng C Gear

IMPORTANT INFORMATION FOR LOG SPLITTER USERSALWAYS:Use clean fluid and check fluid level regularly Use Dexron II Automatic Transmission Fluid cr 10W n

For Replacement Parts, ContactSERVICE DEPARTMENT • P.O. BOX 368022 • CLEVELAND, OHIO 44136-9722

IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND

2. Know how to stop the unit and disengage the cont [ols.3. Never place hands or feet between log and splitti ig wedge or between log and end plate

ASSEMBLY INSTRUCTIONSTools Required for Assembly(1) Soft Hammer or Mallet(2) 9/16" Wrenches*(2) 1/2" Wrenches*(1) 7/16" Wrench*(1) Ad

6. Place one flat washer just removed on each axle. Secure with hex slotted nut. Tighten slotted nut until snug, then back off approximately 1

Hex LockFIGURE 6.ControlHandleClevis Pin Cotter PinINSTALLING THE HITCH1. Using two 9/16" wrenches, remove the hardware which is assembled throu

FIGURE 9.ATTACHING THE HOSESSuction Hose1. The suction hose is attached to the reservoir tank, beneath the engine mounting bracket. See-----figure 9.

OPERATIONINITIAL PREPARATION1. Place the log splitter on a firm, level surface.2. Service engine with gasoline and oil asinstructed in the separate